Durable, Corrosion Resistant The Pall range of non-metallic single cartridge housings offers an economical answer to low flow requirements. Non-metallic housings are available with polypropylene heads and a choice of polypropylene or SAN bowls to suit a range of chemical applications. Filter assemblies should not be used with fluids incompatible with the materials of construction. These industrial designed housings are ideally suited for use with low flows where a metallic housing is not required.
Design for Liquid Applications
- Cost effective alternative to stainless steel in corrosive fluid applications
- Accepts 20 in. (50.8 cm) DOE or Pall M5 (Code 5) style cartridge
- Fixed guides in head and shell ensure proper alignment and seating of cartridges
- Manufactured from materials which are listed for Food Contact Applications in Title 21 of the U.S. Code of Federal Regulations
4.1 (9)Materials of Construction
LMO-UP: SAN (Styrene Acrylonitrile)
Maximum Operating Pressure
- LMO-U: 8.6 bar (125 psig) @ 52 °C (125 °F)
- LMO-UP: 6.9 bar (100 psig) @ 66 °C (150 °F)
- Inlet/outlet: 3/4" NPT
- Ethylene propylene (standard), Nitrile, neoprene, fluorocarbon elastomer
- LMO-U: Opaque with blue head and shell
- LMO-UP: Blue head and clear shell
Food and Water Contact UsePlease contact Pall Corporation to verify that the product conforms to your national legislation and/or regional regulatory requirements for water and food contact use.
|Ultra Violet Light||Recommended||Fair|
|Weak Acid (<20%)||Recommended||Recommended|
|Organic Solvent||Recommended||Not Recommended|
|Strong Oxidizing Agent||Recommended||Not Tested|
|Weak Base (<20%)||Recommended||Recommended|
This housing is not recommended for compressed air or gas service. It is suitable for use with fully compatible (which do not soften, swell or adversely effect the product or its materials of construction) liquids only. This housing is not recommended for acid service at the pressure shown. Please contact Pall for detailed compatibility information.NOTE: Use of this product in a manner other than in accordance with Pall’s current recommendations may lead to injury or loss. Pall cannot accept liability for such injury or loss.
Dimensional Date (Nominal)
|Dimensions cm (in.)|
|Model||Liquid Flow Rate2 lpm (gpm||A||B||Weight kg (lb)|
|LMO20U-3/4||to 75.7 (20)||57.2 (22.5)||13.7 (5.38)||4.1 (9)|
|LMO20UP-3/4||to 75.7 (20)||57.2 (22.5)||13.7 (5.38)|
Housing Differential Pressure vs. Liquid Flow Rate
Unit conversion: 1 bar = 100 kpa
For liquids other than water, multiply differential pressure by the specific gravity of the fluid.
1Housing head has mounting bosses, which accept self-tapping screws for attaching a bracket to the housing.
2Dependent upon cartridge selection, fluid viscosity and allowable pressure drop.
Example Part Number: LMO 20 U -3/4 (See bold references in table below)Part Number: LMO 20 < Code from Table 1 > -3/4
Table 1 - Material of Construction
|Code||Materials of Construction|
Beer (Craft/Micro Breweries)