Notes and Specifications Filter Housing

• Fatigue Pressure Rating
  14 bar (200 psi) (100,000 cycles 0-200 psi)
• Typical Burst Pressure:
  20 bar (290 psi)
• Filter Element Collapse Pressure:
  7 bard (100 psid)
• Fluid Compatibility:
  Compatible with all petroleum oils and most water glycols, water-oil
  emulsions, and synthetic hydraulic and lubricating fluids
• Temperature Range:
  -29 ˚C to 120 ˚C (-20 ˚F to 225 ˚F)
  60 ˚C (140 ˚F) maximum in HWCF or water glycols
• Bypass Valve Setting:
  1.7 bard (25 psid)
  3.4 bard (50 psid)
  Non-bypass
• Indicator Pressure Setting:
  1.1 bard (16 psid) with ‘A’ valve option
  2.4 bard (35 psid) with ‘B’ and ‘W’ valve option
• Housing Materials of Construction:
  Cast iron head

Dimensional Drawings

Dimensions in mm (inches)

The equipment has been assessed in accordance with the guidelines laid down in The European Pressure Directive 97/23/EC and has been classified within Sound Engineering Practice S.E.P. Suitable for use with Group 1 and 2 fluids only. Consult Sales for other fluid gas group suitability.

Pressure Drop Information

Housing pressure drop using fluid with 0.9 S.G.

Element Pressure Drop

Multiply actual flow rate times factor in table below to determine pressure drop with fluid at 32 cSt (150 SUS), 0.9 S.G. Correct for other fluids by multiplying new viscosity in cSt/32 (SUS/150) x new S.G./0.9.

7500 Series Element DP Factors (psid/gpm)

7502 Series Element DP Factors (psid/gpm)

Section 1 Housing P/N:

Note: Pall Athalon filter housings are supplied without filter elements or warning devices fitted. Never operate the filter unless a filter element is fitted and all warning device ports are sealed.

Housing part number designates indicator port is fitted with a plastic shipping plug.

Section 2 Element Spin-On Can
P/N: HC7500 S[Table 1] [Table 2] H

Note:2 cans are required for 7502 Series housings

Table 1: Filter Performance Ratings

* based on 60 psid terminal pressure drop

Table 2: Length Options

Section 3

Differential Pressure Indicator
P/N: RC [Table 3] Z [Table 4] Z

Note: If no Differential Pressure Indicator is selected, ‘B’ type blanking plug (P/N HC9000A104Z) must be ordered separately and fitted to replace the shipping plug.

Note: Z indicates fluorocarbon seals are standard. Other options are available; contact Pall.

Table 3: Indicator Options

Table 4: Indicator Pressure Setting Option