For Particle Removal at Elevated Flow RatesUltipleat High Flow filter elements are designed for cost-effective, highly efficient particle filtration in high flow rate food and beverage applications.
The Ultipleat High Flow filter elements are designed for high flow rates up to 113 m3/hour (500 US gal/min) in a single 1524 mm (60 inch) cartridge. They utilize Profile UP media with unique, laid-over pleat geometry. The Ultipleat High Flow element is a large diameter, single open ended, pleated cartridge with an inside to outside flow pattern and a core-free construction.
The filter's unique, laid-over pleat geometry, combined with its large diameter means fewer elements are required for a given flow rate than standard diameter cartridges. Filter vessels are correspondingly smaller, resulting in lower capital and installation costs, as well as reduced operating costs.
|Fixed fiber matrix with no adhesives or surfactants|| |
|Pleated (laid-over pleat geometry) media in a large diameter cartridge format|| |
|Inside to outside flow configuration||Protects filtrate from recontamination by trapping particulates inside the cartridge|
*Typical compared to standard cartridges used in test comparison.
Please contact your Pall representative for individual fluid applications and product options more suitable to lower flow rates.
Materials of Construction
|Support Mesh and Outer Wrap||Polypropylene|
|End Caps and Handle||Polypropylene (10% glass fiber reinforced)|
|O-ring Seal||Ethylene Propylene Rubber|
Food Contact CompliancePlease refer to the Pall website for a Declaration of Compliance to specific National Legislation and/or Regional Regulatory requirements for food contact use.
Technical InformationThe technical information provided is based on controlled laboratory tests done on typical production filters at the conditions described, unless otherwise indicated. Actual operating conditions may affect the filter's performance.
Operating Characteristics in Compatible Fluids1
|Maximum Differential Pressure||Max. Operating Temperature2|
|3.45 bard (50 psid) (inside to out flow)||82 °C (180 °F)|
1 Fluids which do not swell, soften or adversely affect any of the filter components.
2 Not recommended where the temperature is cycled by more than 28 °C (50 °F).
Maximum temperatures are for continuous service.
Figure 1: Ultipleat filter element construction, showing unique laid-over pleats and uniform flow distribution
Typical Flow Rates3
3 Typical initial clean delta p, for 1016 mm (40") and 1524 mm (60") elements, water at 20 °C (68 °F). For assistance in filter assembly sizing, especially for fluids with a viscosity greater than 1 centipoise, contact your Pall representative.
- Cartridges produced in a controlled environment
- Manufactured according to ISO 9001:2008 certified Quality Management System
Large Format Filters
This information is a guide to the part number structure and possible options. For availability of specific options and housing details, please contact Pall.
Example Part Number: HFU 6 40 UY020JUW (See bold references in tables below.)
Element Part Number: HFU 6 <Nominal Length Code from Table 1> <Liquid Removal Rating Code from Table 2> JUW
Table 1 - Nominal Length
|40||1016 mm (40 in.)|
|60||1524 mm (60 in.)|
Table 2 - Liquid Removal Rating4
|Code||Rating (μm) at 99.98% Efficiency (ß-5000)||Rating (μm) at 99% Efficiency (ß-100)|
4The UY400 grade was qualified by maximum spherical particle retention test.
Earn 10% off* your next order online by leaving a review of this product. Please login to your account to leave a review. We appreciate and value your feedback.
*Subject to Terms and Conditions.