- Epoxy Impregnated Cellulosic Media with a Fixed Pore Construction Eliminates Unloading and Media Migration
- Broad Chemical Compatibility
- Recommended for Use with a Wide Range of Fluids and Gases Including Photographic Emulsions and Developer Chemicals, Lube Oil, Printing Inks, Air, Nitrogen, Ammonia and Natural Gas
- Not Recommended for Food or Pharmaceutical Applications
Maximum Differential Pressure
||80 psid (5.5 bard) @ 122ºF (50ºC)
45 psid (3.1 bard) @ 180ºF (82ºC)
|Stainless Steel Hardware:||75 psid (5.2 bard) @ 275ºF (135ºC)|
Materials of Construction:
|Filter Media:||Epoxy Impregnated Cellulose|
|Hardware:||Polypropylene or 300 Series Stainless Steel|
|Gaskets:||Buna N, fluorocarbon elastomer1 A, Ethylene Propylene|
Industrial (1001 style):
|Outside Diameter:||2 3/4" (70 mm)|
|Length:||10" (254 mm)|
|Configuration:||DOE with stainless steel hardware|
UNI CAP Style:
|Outside Diameter:||2 1/2" (64 mm)|
||10" (254 mm), 20" (508 mm),
30" (762 mm), 40" (1020 mm)
|Configuration:||DOE with polypropylene hardware|
Small Flow (4463 style):
|Outside Diameter:||2 1/4" (57 mm)|
|Length:||5 1/4" (133 mm)|
|Configuration:||SOE with stainless steel hardware|
Removal Ratings and Flow Specifications
Clean Pressure Drop4 per 10"
PSID per 1 GPM (mbard/lpm)
(UNI CAP & 1000 Style)
1 - Registered trademark of DuPont Dow.
2 - Nominal Filtration Rating:
Pall ratings reflect a higher than average 98% removal by weight.
The diameter of the largest hard spherical particle that will pass through a filter under specified test conditions.
This is an indication of the largest opening in the filter element.
4 - Pressure drop in psi per gpm water for a single 10" (254 mm) module. Multiply this value by the required flow to
determine the total aqueous pressure drop. For fluids other than water, multiply differential pressure by viscosity (cP).
If this calculated pressure drop is excessive, then divide this value by the number of 10" modules required to reduce
this pressure drop to an acceptable level.
Housing InformationHousings are available in polypropylene, carbon steel, or
stainless steel and can accommodate one to 356 10" modules
per housing. Contact Pall for further details.
Part Numbers/Ordering Information
Element Part Number
UNI CAP Style: PUY
Industrial 1001 Style: MCS 1001
Small Flow 4463 Style: MCS 4463 EC
(Standard for 1001 Style)
|H||fluorocarbon elastomer A|
(Standard for UNI CAP Style)