Relative Retention Rating1
Food Contact Compliance
- Food contact compliant filters are available. Please consult the Declarations of Compliance for applicable part numbers at the links below.
- Please refer to the Pall website for a Declaration of Compliance to specific National Legislation and/or Regional Regulatory requirements for food contact use.
Main Constituents
Cellulose, diatomaceous earth (DE, Kieselguhr), perlite
Characterization
| Grade |
Mass per Unit
Area g/m2 |
Thickness
mm |
Ash
% |
Water Permeability2
L/m2/min
(gal/ft2/min) |
| KS 50 IR |
1350 |
3.7 |
46 |
93 (2.3) |
| K 100 IR |
1400 |
4.3 |
51 |
187 (4.6) |
| K 250 IR |
1250 |
4 |
46 |
510 (12.5) |
| K 800 IR |
1250 |
4.1 |
46 |
1275 (31.4) |
These figures have been determined in accordance with in-house test methods and the methods of the Technical / Analytical Work Group within the European Depth Filtration Association.
2The permeability was measured under test conditions with clean water at 20° C (68° F) and a Δp of 1 bar (14.5 psi).
The diagram below illustrates the release of calcium and magnesium from the comparable standard filter sheet K100 and K100 IR into whisky during filtration.
The following total calcium and magnesium release per m2 filter sheet at a flow velocity of 500 L/m2/h (12.3 gal/ft2/h) was calculated during this filtration run:
| Sheet |
Calcium mg/m2 (%) |
Magnesium mg/m2(%) |
| K 1003 |
667 (100) |
192 (100 |
| K 100 IR |
146 (22) |
68 (35) |
3The K 100 is the comparable standard sheet to the K 100 IR with regard to the material composition.
Quality
- Filter sheets produced in a controlled environment
- Manufactured according to ISO 9001:2015 certified Quality Management System
The use of ion-reduced water (deionized water) is highly recommended for the reconstitution of distillates to single strength.
To prevent dilution upon installation, a water rinse is not recommended for sheet filters used in the spirits industry. Product circulation for 10 to 15 minutes back to the feed tank helps distribute ions extracted at the beginning of filtration to the entire batch, reducing precipitation's overall risk.
Filtration Guidelines4
As the filtrate quality can be impacted by the filtration flow rate, the following table provides flux rate guidelines.
| Application |
Flow Velocity L/m2/h (gph/ft2) |
| Particle filtration of brown spirits |
500 – 700 (12.3 – 17.2) |
| Particle filtration white spirits |
700 – 900 (17.2 – 22.1) |
| Chill filtration of brown spirits and white spirits high in fatty acids |
250 – 400 (6.1 – 9.8) |
| Chill filtration of white spirits |
400 – 600 (9.8 – 14.7) |
4 Please contact Pall for recommendations on your specific filtration process as results may vary by product, pre-filtration and filtration conditions.
For additional operating guidelines, please refer to the instructions provided by Pall.
FEATURED
